Indoor Explosion Venting – Flameless Venting
BRILEX single section design Explosion Vents in combination with a unique Ceramic Filters are economical for venting of dust explosions inside production buildings.As the explosion vent opens, the ceramic filters are designed to retain the dust and cool down the hot gases.
Existing quench pipes are uneconomical, not re-usable or have lower venting efficiencies and require high vessel strengths. The BRILEX IndoorVent offers unlimited use with the highest known venting efficiency.
Prior to the introduction of the Brilex Indoor Vent, high costs and poor venting efficiencies led to design engineers and end users to try to find alternatives. The BRILEX IndoorVent offers a combination of a fast opening BRILEX Explosion Vent with highly efficient ceramic filters. The certified effective relief vent area of the IndoorVent is greater than the vent areas of existing quench pipes. After an explosion the IndoorVent can be re-used. The result is a cost effective solution for plant designers and end users for all industries.
The BRILEX IndoorVent is certified for use with reduced explosion pressures (P red) between 0.2 to 1.5 bar g and Kst values up to 250 bar m/sec.
After an Explosion
Times have changed since explosion quenching systems had to be thrown into the waste bin after single use. The BRILEX IndoorVent can be re-used after changing the filter cartridges and the explosion vent. Maintenance time of approximately 30 minutes is only needed before it can be used again. BRILEX guarantees this after each dust explosion.
BRILEX delivers complete units consisting of the IndoorVent and a pre-installed BRILEX explosion vent including integrated flange gaskets and monitoring sensor. A spare parts kit for immediate use after an explosion consisting of explosion vent and filter cartridges.
The BRILEX IndoorVent has been tested by well-known institutions and is certified according to the (94/9/EC) ATEX 100 standard. BRILEX is certified to DIN EN ISO 9001 : 2008 Approvals and Certificates.
|Type||IV 240||IV 600||IV 1000||IV 1600||IV 2200||IV 3200||IV 4200|
|Flange||DN 200||DN 300||DN 400||DN 500||DN 600||DN 700||DN 800|
|Vent area (cm²)||240||600||1000||1600||2200||3200||4200|
|A/B Length / width (mm)||359||410||558||666||785||983||1096|
|Max. raw gas volume (m³) pro IV||1||4,4||4,4||9,7||9,7||25||25|
|Max. Pred (bar)||1.5||1.5||1.5||1.5||1.5||0.6||0.6|
BRILEX IndoorVentEXL for venting of dust explosion in production buildings.
– Cost reduction due to optimised manufacturing
– Higher Certified Effective vent areas due to extendable modules
– Extendable from 1900 cm²; to 3100 cm²;
– Integrated explosion vent and sensor
– Tested up to P red max 0,9 bar
– Certified For dusts up to KST 200 bar.m/sec
– Guaranteed re-usability after an explosion
IV EXL 457 x 890 SB
|IV EXL 457 x 890 DB||
IV EXL 457 x 890 DB
457 x 890
|457 x 890||
457 x 890
|Vent Area (cm²)||
|Length/ width/ height (mm)||
970 / 540 / 875
|970 / 540 / 1635||
970 / 540 / 1635
|Max. raw gas volume (m³) pro IV||
|Max. P red (bar)||
|Max. Kst- Value (bar m/s)||